Table of Contents
Advertisement
Installing a surface-mounted
hob
Create the worktop cut-out. Remem-
ber to maintain the minimum safety
distances (see "Installation – Safety
distances").
Seal any cut surfaces on wooden
worktops with a special varnish, sil-
icone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
Attach the sealing strip provided un-
derneath the edge of the hob. Do not
apply the sealing strip under tension.
Risk of damage from incorrect
connection.
The hob electronic module may be
damaged if a short circuit occurs.
The mains connection cable must be
connected to the hob by a qualified
electrician.
Connect the mains connection cable
to the hob by following the instruc-
tions in the wiring diagram (see "In-
stallation – Electrical connection").
Feed the mains connection cable for
the hob down through the worktop
cut-out.
Place the hob centrally in the cut-out.
When doing this, make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is im-
portant to ensure an effective seal all
round.
If the seal does not sit flush with the
worktop in the corners, the corner ra-
dius (≤ R4) can be carefully cut to fit
using a jigsaw.
If an air intake-optimised base panel
is installed, position the hob so that
the fans are located above the cut-
outs.
Connect the hob to the electricity
supply (see "Installation – Electrical
connection").
Check that the hob is working.
Installation
91
Advertisement
Table of Contents
