Yamaha PASC4 Owner's Manual page 89

Lock-release ring
Lock-release ring
PASC4
8. Confirm that charging is complete, and then disconnect
the charging plug from the Battery Pack.
How to disconnect the charging plug of Battery Charger
type PASC4 (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
9.
tor.
The Multi Location Battery and External Crossover Bat-
tery are not equipped with a cap.
10. Mount the Battery Pack on the bicycle.
WARNING
Do not touch Battery Charger contacts with metal-
lic objects. Do not allow foreign material to cause
short circuit of the contacts. This could result in
electric shock, fire, or damage the Battery Charger.
Periodically remove dust from the power plug.
Dampness or other issues could reduce the effec-
tiveness of the insulation, resulting in fire.
Never disassemble or modify the Battery Charger.
This could result in fire or electric shock.
Do not use with a power strip or extension cord.
Using a power strip or similar methods may exceed
rated current and can result in fire.
Do not use with the cable tied or rolled up, and do
not store with the cable wrapped around the Bat-
tery Charger main body. Cable damage can result
in fire or electric shock.
Firmly insert the power plug and the charging plug
into the socket. Failure to insert the power plug and
the charging plug completely can result in fire
caused by electric shock or overheating.
Do not use the Battery Charger near flammable ma-
terial or gas. This could result in fire or explosion.
Never cover the Battery Charger or place other ob-
jects on top of it while charging. This could result
in internal overheating leading to fire.
Before equipping the bicycle with a Multi Location
Battery, make sure that there is no foreign matter
or water in the connector on the bicycle. Otherwise,
it could lead to heat generation, smoke and/or a fire
owing to short-circuiting of the terminals.
85
-