Yamaha PASC4 Owner's Manual page 41

Power supply to external devices
Power can be supplied to most external devices (e.g. vari-
ous smart phones etc.) by connecting a commercial USB
2.0 OTG cable.
[To supply power]
1. Open the USB port cap of the display.
2. Connect the USB cable to the display and external de-
vice.
3. Turn on the power of the vehicle.
[To stop the power supply]
1. Turn off the power of the vehicle.
2. Disconnect the USB cable and put on the cap of the
USB port.
NOTICE
Do not apply unreasonable force on the USB plug
or pull the USB cable.
Check that the USB plug is facing the right way and
not totally out-of-position with the USB port or
slanted, and make sure it is fully inserted all the
way in.
Do not connect the USB port and the USB plug in a
wet state.
Use a USB 2.0 OTG cable that conforms to the
standards.
Do not insert foreign objects into the USB port unit.
Otherwise the Display Unit and external device may
malfunction.
TIP
Power is supplied automatically when an external de-
vice is connected with the USB cable.
No power is supplied if the remaining capacity of the
Battery Pack is low.
The power supply of the vehicle will go off and power
supplied by the USB connection will also stop if the ve-
hicle is not operated for 5 minutes.
37