Yamaha PASC4 Owner's Manual page 16

Display Unit (Display A2)
The Display Unit offers the following operations and infor-
mation displays.
Power on/off
Each time you press the power switch, the power is turned
on and off.
When you turn on the power, all of the displays come up.
After that, the main riding display is shown.
TIP
When you turn on the power, the assist mode is auto-
matically set to Off Mode.
Keep your feet off the pedals when turning on the Dis-
play Unit. Also, do not start riding immediately after
turning on the Display Unit. Doing so could weaken the
assist power. (Weak assist power in either of these
cases is not a malfunction.) If you did either of the
above by accident, remove your feet from the pedals,
turn on the power again, and wait a moment (approxi-
mately two seconds) before starting to ride.
Displaying and switching the assist mode
You can select the assist mode by using the assist mode
switches (up) or (down).
The selected assist mode is displayed by the assist mode
indicator.
When you press the assist mode switch (up), the mode
When you press the assist mode switch (down), the
mode changes from
TIP
Bicycles equipped with the PWseries CE, PWseries
C2, PWseries ST, and PWseries S2 Drive Unit have no
Extra Power Mode.
Further pressing of the assist mode switch will not cy-
cle the assist mode selections.
12
to or from