Troubleshooting - Blomberg BLPE 1 User Manual

7

Troubleshooting

Problem
The appliance does not
work.
No or delayed response
in several attempts of
pressing a function key
on the panel
The coffee is not hot
enough.
Coffee is not coming out
of the coffee spout.
The first cup of coffee is
of poor quality.
The water tank is re-
moved / the water level is
very low in the water tank
" "
but there is no
The internal drip tray is
filled with a lot of water.
34 / EN
Cause
The appliance is not connected
to the mains.
Appliance is under electro-
magnetic interference. The
panel is dirty.
The cups have not been pre-
heated.
The brewing unit is too cold.
The empty system function may
have been used previously.
The coffee spout may not have
been cleaned and is blocked by
coffee residues.
The first running of the grinder
does not place a sufficient
quantity of coffee into the
brewing unit.
The area near the water tank
connector could be wet.
alert.
The ground coffee is too fine,
which blocks the water from
coming out.
Fully Automatic Coffee Machine / User Manual
Solution
Plug in and press the switch.
Check the cable and the plug.
Unplug the appliance. Re-
start after a few minutes
Clean the panel with the
cloth provided.
Place your cup on the cup
warmer facing down or rinse
the cup with hot water.
Make sure that the water
in the water tank is not too
cold.
Press the hot water button
until water comes out of the
spout.
Clean the coffee spout.
Throw the coffee away. The
next cups
will be better.
Wipe off the water around
the water tank connector.
Adjust the coffee fineness to
larger grains for the grinding
process.