3-Wire Connection
Connect line
1 here.
Ground
strap
terminal block
Connect line 2 here.
A user supplied strain
relief clamp must
be installed at this
location.
It requires 1 3/8-
inches (3,5 cm)
iameter cord kit hole.
Fig.7
Note: Install strain relief clamp. Center must always be attached
to the central terminal on block.
•
To align the appliance with the worktop, adjust the feet turning right or left hand as
required.
For products with cooling fan
The built-in cooling fan cools both the
built-in cabinet and the front of the
product.
H Cooling fan continues to operate for
about 20-30 minutes after the oven
is switched off.
1. Cooling fan
2. Control panel
3. Door