Table of Contents
Advertisement
Note: For 3- wire permanent connection
skip steps 3 and 4 and continue with step
5
.
3
Disconnect the ground strap. Remove
the factory installed ground screw and
lug connector to release the factory
installed copper ground strap from
frame of the range. Cut and discard
the copper strap from the terminal
block. Keep the ground screw, lug
connector and go to step 4.
4
Connect the green ground wire lead
to the frame of the range using the
ground screw and lug connector as
shown in figure 6. Be sure to install
using the same hole in the frame
where the ground screw was origin
installed.
5 Make sure all connections are Torq
35 Ibs/inches tightened securely ar
replace the rear access cover. See
Figure 4.
Note: Non-terminated field wire
compression connections must be set
approximately 90 in./lbs.
4-Wire connection
Lug
connector
Ground
Ground wire
lead.
Connect line
1 here.
Cut ground str
Discard grounc
and lug conne(
Connect green it
copper ground v
ground screw he
Proper ground for
4-wire permanent
connection
Note: Install strain
roiiof clamp. Center
hite wire must
ys be attached
e central
inal on block.
lect neutral
e or center)
A user supplied
rain relief clamp
lust be installed
at this location.
It requires 1 3/8
Advertisement
Table of Contents
