Brake Maintenance; Checking The Brake Fluid - Toro Multi-Pro 1250 Operator's Manual

Figure 54
1. Tire center line-back
2. Tire center line-front
3. Axle center line
5. If the measurement does not fall within the specified
range, loosen the jam nuts at both ends of the tie
rods (Figure 55).
Figure 55
1. Jam nut
6. Rotate both tie rods to move the front of the tire
inward or outward.
Note: The tie rods should be the same length when
you are finished.
7. Tighten the tie rod jam nuts when the adjustment is
correct.
8. Ensure that there is full travel of the steering wheel
in both directions.
4. Fixture
5. Axle center line distance
6. 6 inches (15 cm) ruler
2. Tie rod

Brake Maintenance

Checking the Brake Fluid

The brake fluid reservoir is shipped from the factory
filled with DOT 3 brake fluid. Check the level before
starting the engine each day.
1. Brake fluid reservoir
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove
the ignition key.
2. The fluid level should be up to the Full line on the
reservoir (Figure 57).
1. Full line
3. If the fluid level is low, clean the area around the
reservoir cap, remove the cap, and fill the reservoir
to the proper level. Do not overfill.
49
Figure 56
Figure 57