Advertisement
Remove the two screws that hold the front
panel, and remove the panel.
Route the receiver's cable into the hy-
drobox through the leftmost inlet at the
bottom of the unit. Then route into the
EN
control and electrical box through the
shown inlet at the bottom of the con-
trol and electrical box.
through.
Refer to
,
, and
and
.
devices (e.g. radio, induction heating
cooker, microwave oven, refrigerator,
and mobile phone or the like) at least 50
cm away from the wireless receiver.
Place the wireless receiver in an inter-
ference-free area and keep the wireless
receiver away from metal.
Refer to
and
7
in "4.1. Connecting to Cylinder unit" in this manual for the procedures
in "4.1. Connecting to Cylinder unit" in this manual for the procedures
Front panel
Screws
(2 positions)
Control board
Control and
electrical box
and
.
Advertisement
