Advertisement
Test wireless communication between the wireless remote controller and the wireless
receiver.
(See "6.4. Communication Test" in "6. Setting wireless remote controllers" in this manual.)
Position the wireless remote controller in an appropriate place.
(See "4. Before Operation" in OM.)
To set the wireless remote controller as a room sensor that monitors room temperature,
see "Main remote controller Options" in IM.
Use the main controller to set the ecodan system to the room temp. (
less remote controller will operate as a thermostat. (See "Main remote controller" in IM.)
munication error.
Remove the two screws that hold the front panel, and remove the panel.
Remove the screw and pull the control and electrical box so that the control and electrical
box is swung toward you from left.
Front panel
Screws (2 positions)
) mode or the compensation curve (
to
Control and electrical box
Screw
(1 position)
) mode is selected, the wire-
.
Control and electrical box
Screws
(2 positions)
) mode.
4
EN
Advertisement
