Canon imagePASS-P2 Service Manual page 59

14. Flip the service switches to normal mode (both switches set to OFF).
For an illustration of the service switch modes, see above figure.
IMPORTANT:
If you do not remove the USB flash drive (step 13) and do not flip the service switches to normal mode (step 14), when the
imagePASS is starting up, it will try to copy the files again from the USB, and cause the imagePASS start up to fail.
15. Reconnect the cables to the imagePASS (see
• Connect the network cable between the imagePASS and the customer network.
• Connect the crossover Ethernet cable between the imagePASS and the printer.
NOTE:
Be sure to use the correct cable for each connection.
16. Make sure that the imagePASS power switch is in the ON (|) position.
17. Power on the printer using the main power switch.
Allow the imagePASS to start up and reach Idle (00 should appear on the imagePASS LED display).
NOTE:
If you press the Fiery icon on the printer touch panel before the imagePASS finishes the startup process, "TCP connect error"
appears on the printer touch panel. Press OK to return to the Home screen, and wait until the imagePASS reaches Idle.
Wait approximately 15 minutes longer for the imagePASS to start up and print Start page.
18. If you saved a configuration file earlier, restore the system configuration (see
42).
NOTE:
If it was not possible to save a configuration file or if you installed an upgraded version of system software, you must configure
Setup using the Configuration pages you printed earlier. For information about performing Setup, see Configuration and Setup,
which is part of the user documentation set. Bypass any settings if it is more appropriate for the site administrator to set them.
After you exit Setup and allow the system to reboot, ask the site administrator to restore the custom files that were archived earlier.
19. Install any required software patches:
• If you reinstalled the same version of system software, be sure to reinstall all software patches that were previously
installed on the imagePASS. For a list of installed patches, see the Configuration pages that you printed earlier.
• If you installed an upgraded version of system software (for example, version 1.0 to version 2.0), contact your authorized
service/support center for a list of valid software patches. Some or all of the patches listed on the Configuration pages
that you printed earlier may no longer be valid. Before installing a patch, be sure to verify with your authorized service/
support center that it is valid for your system version. Installing an invalid patch may result in system corruption.
20. Reconnect any USB devices that you may have removed earlier.
21. If the imagePASS requires a static IP address (for example, in a non-DHCP network environment), work with the network
administrator to configure it (see the Configuration and Setup which is part of the user documentation).
■ Install the system software through network connection
Using the Fiery Installer Builder you can install the system software stored on a network location. All the data on the HDD and
the configuration information will be lost, make sure to create a backup of the data or system configuration.
● To install the system software through the network connection
1. Remove all the USB devices that may be connected to the imagePASS.
2. If possible, print the Configuration pages (see
The Configuration pages contain a list of any installed options and a record of the customer's current Setup configuration.
"imagePASS connector panel and LED diagnostic codes" on page
"Printing the Configuration pages" on page
54
4. INSTALLING SYSTEM SOFTWARE
"Restoring the system configuration" on page
58).
14):