Canon imagePASS-P2 Service Manual page 32

Table of Contents

Advertisement

■ Replacing the motherboard
Use the following procedure to install the motherboard in the imagePASS chassis.
● To replace the motherboard
1. If you are installing a new motherboard, do the following:
• Remove the security chip from the old motherboard and install it onto the new motherboard(see
chip" on page
25).
• Install the DIMM(s) from the old motherboard onto the new motherboard(see
• Install the CPU from the old motherboard onto the new motherboard(see
28).
When installing these components, make sure that the motherboard is placed on an antistatic surface with some padding.
Do not transfer the BIOS chip from the old motherboard onto the new motherboard. Doing so can cause the system to shut
down due to incompatibility issues.
2. Angle the motherboard so that the connectors on the motherboard fit into the cutouts in the connector panel of
the chassis, and gently slide the motherboard into the chassis (see
NOTE:
As you slide the motherboard into position, lift the connector edge to ensure that the underside of jumper area PCIEX8 clears the
nearby screw standoff.
IMPORTANT:
Be sure to fit the motherboard Ethernet connectors under the metal grounding tabs in the cutouts. Failure to position the
grounding tabs correctly may result in permanent damage to the motherboard and power supply.
No.
1
Metal grounding tab
2
Motherboard connector
3. Align the mounting holes on the motherboard with the screw holes located in the base of the chassis (see
jumpers" on page
23).
4. Insert the six mounting screws that attach the motherboard to the chassis.
Partially tighten each screw before completely tightening any one screw. Do not overtighten the screws; doing so could
damage traces on the motherboard.
Now you are ready to replace the remaining motherboard components to complete the motherboard installation.
Figure 17: Fitting the connectors under the metal grounding tab
"DIMM" on page
"CPU and CPU cooling assembly" on page
"To remove the motherboard" on page
Item
27
3. REPLACING PARTS
"Transferring the security
20).
24).
1
2
"Motherboard

Advertisement

Table of Contents
loading

Table of Contents