Tx Power Setup - Kenwood ProTalk NX-P1200AV User Manual

TX Power Setup

To set the Transmit Power
During CHANNEL SETUP, rotate the Selector to select a channel number.
1
• The transceiver announces the zone number and channel number.
Press the Side 1 or Side 2 button to select the TX Power Setup Mode.
2
• The transceiver announces "TX Power".
• If the Frequency of the currently selected channel is set to "Off", the TX
Power Setup Mode cannot be selected.
Press the PTT switch to enter the Transmit Power Selection.
3
Press the Side 1 or Side 2 button to select the Transmit Power.
4
NX-P1200NV/ NX-P1200AV/ NX-P1300NU/ NX-P1300AU
Transmit Power
High
Medium
Low
NX-P1202AV/ NX-P1302AU
Transmit Power
High
Low
Press the PTT switch to temporary save the selected Transmit Power.
5
• Beep B (2 beeps) will sound.
• Repeat steps 1 to 5 to set up another channel.
Press the Side 1 or Side 2 button to select the Confirmation Setup Mode.
6
• The transceiver announces "Conrm".
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
7
SELECTION
• Beep B (2 beeps) will sound.
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
Voice Announcement
TX Power High
TX Power Medium
TX Power Low
Voice Announcement
TX Power High
TX Power Low
33
Description
5 W
4 W
1 W
Description
2 W
1 W