Channel Setup; Frequency Setup - Kenwood ProTalk NX-P1200AV User Manual

CHANNEL SETUP

Frequency Setup

To set the Frequency
During CHANNEL SETUP, rotate the Selector to select a channel number.
1
• The transceiver announces the zone number and channel number.
Press the Side 1 or Side 2 button to select the Frequency Setup Mode.
2
• The transceiver announces "Channel".
Press the PTT switch to enter the Frequency Table Selection.
3
• The transceiver will announce the current frequency table number.
Press the Side 1 or Side 2 button to increment/ decrement the frequency table
4
number, to select the new channel frequency.
• A voice announcement: "Table X" (X = 1 to 27 for VHF, X = 1 to 99 for UHF).
• A voice announcement will inform you of the currently selected frequency
table number.
• Table numbers and their corresponding operating frequencies are provided
in the table {VHF: p. 24} {UHF: p. 25}.
• Press and hold the Side 1 or Side 2 button to increment/ decrement the
frequency table number by 5 at a time.
Press the PTT switch to temporary save the selected frequency table number.
5
• Beep B (2 beeps) will sound.
• Repeat steps 1 to 5 to set up another channel.
Press the Side 1 or Side 2 button to select the Confirmation Setup Mode.
6
• The transceiver announces "Conrm".
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
7
SELECTION.
• Beep B (2 beeps) will sound.
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
23