Ran Setup (Digital) - Kenwood ProTalk NX-P1200AV User Manual

RAN Setup (Digital)

RAN (Radio Access Number) is a signaling system designed for NXDN System.
When a channel is setup with a RAN, squelch will only open when a call
containing a matching RAN is received. If a call containing a different RAN is
made on the same channel are using, you will not hear the call. This allows you to
ignore (not hear) calls from other parties who are using the same channel.
To set the RAN
During CHANNEL SETUP, rotate the Selector to select a channel number.
1
• The transceiver announces the zone number and channel number.
Press the Side 1 or Side 2 button to select the RAN Setup Mode.
2
• The transceiver announces "RAN".
Press the PTT switch to enter the RAN Table Selection.
3
• The transceiver will announce the current RAN table number.
Press the Side 1 or Side 2 to increment/ decrement the RAN table number.
4
• A voice announcement: "RAN X" (X = 0 to 63).
• A voice announcement will inform you of the currently selected RAN table
number.
• When RAN table number set to "0" ("RAN 0"), RAN signaling is off.
• Press and hold the Side 1 or Side 2 button to increment/ decrement the
RAN table number by 5 at a time.
Press the PTT switch to temporary save the selected RAN table number.
5
• Beep B (2 beeps) will sound.
• Repeat steps 1 to 5 to set up another channel.
Press the Side 1 or Side 2 button to select the Confirmation Setup Mode.
6
• The transceiver announces "Conrm".
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
7
SELECTION
• Beep B (2 beeps) will sound.
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
32