Id Setup; Nxdn Id Setup (Digital) - Kenwood ProTalk NX-P1200AV User Manual

ID SETUP

NXDN ID Setup (Digital)

NXDN ID Setup allows you to congure an identication code. NXDN ID (Own unit
ID) can be used to identify the transceiver in an NXDN System.
You can set the NXDN ID from 00001 to 65519. The default NXDN ID is "00001".
To set the NXDN ID
With the transceiver power OFF, press and hold the Side 1 button and PTT
1
switch while turning the transceiver power ON.
• Continue to hold the Side 1 button and PTT switch until the LED lights
yellow and the transceiver announces "Self".
Release the Side 1 button and PTT switch to enter the ID SETUP/ ZONE
2
SELECTION.
• The transceiver announces "NXDN ID".
Press the PTT switch to enter the NXDN ID Setup Mode.
3
Turn the Selector to set the pointer to the desired digit (1 ~ 5).
4
• A voice announcement will inform selected number.
• If you select more than 5 digit, error beep will sound.
Press the Side 1 to increase the number, press the Side 2 to decrease the
5
number (0 ~ 9).
• A voice announcement will inform selected number.
• Repeat steps 4 to 5 to select the number of each digit.
• For example, when you set the NXDN ID as "12345", you should operate
the Selector, Side 1 and Side 2 buttons according to the following table.
Selector position
Selected number
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
6
SELECTION.
• A voice announcement will inform you of the currently selected NXDN ID
number. For example, when "12345" is selected, voice announcement: "ID,
One, Two, Three, Four, Five".
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
4
5
2
1
19
3 2
3 4
1
5