Operation - Toro 08761 Operator's Manual

Greasing the Nail Drag
Before operating the nail drag, grease it; refer to
Lubricating the Machine (page
Important:
Failure to properly grease the unit will
result in premature failure of critical parts.
6).

Operation

Operating the Nail Drag
•
The amount the drag nails engage in the ground
determines the scarifying depth.
•
To adjust the amount the nails engage in the
ground proceed as follows:
1. Remove the lynch pins from the clevis pins
(Figure 5).
2. Press down on the plates to increase the
scarifying depth or release the plates to
decrease the scarifying depth. Each hole
changes the nail engagement 9/16 inch (14
mm).
3. Install the lynch pins into the desired clevis
pin holes; ensure that all the lynch pins are
set at the same depth.
4
Figure 5
g006213