Toro 08761 Operator's Manual page 3

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Nail drag
No parts required
No parts required
Mounting the Nail Drag
Note:
Determine the left and right sides of the
machine from the normal operating position.
1. Remove any attachment from the rear of the
machine.
2. Back the traction unit into position in front of
the attachment adapter. Lower the traction unit
adapter.
Note:
Ensure that the locking lever is pivoted to
the left (unlocked position) as viewed from the
rear of the machine
1. Locking lever
3. Raise the traction unit adapter into the
attachment adapter.
4. Pivot the locking lever to the right (locked
position) as viewed from the rear of the machine
so that it is standing straight up to lock the
adapters together.
(Figure 3).
Figure 3
2. Attachment adapter
Qty.
1 Mount the nail drag.
–
Adjust the link assembly.
–
Grease the nail drag.
Adjusting the Link
Assembly
1. With the attachment mounted and secured on
the traction unit, raise the attachment.
2. Measure the gap between the top washer
and the spacer in the link assembly on the
attachment adapter as shown in
Important:
the shoulder should be 0.060 to 0.080 inch
(1.5 to 2.0 mm).
g344819
1. Adjustment nut
2. Jam nut
3. 0.060 to 0.080 inch (1.5 to 2.0 mm) clearance
3
Use
Figure
The gap between the washer and
Figure 4
4.
g344820