Mitsubishi Electric MAC-558IF-E Manual page 5

3
Remove the cover of the indoor
unit, the cable terminal, and the
cover to the control board.
5
Run the cables down the back of
the unit with the other cables. Tuck
cabling away and secure.
7
Check that the MAC-558IF-E
Adaptor is flashing. The install has
now been completed.
Please note, the above illustrates high wall unit installation. Installation will vary
depending on indoor model type.
4
Locate the CN105 port on the
main control board and connect
the MAC-558IF-E Adaptor.
6
Reassemble the indoor unit and
restore power to the system.
8
The adaptor is now able to be
connected to the user's router. Steps for
this are shown on the following pages.
5