Table of Contents
Advertisement
Troubleshooting
If at any stage you see the orange LED 2 light up, this is an indication that there is a problem with
the router communicating with the adaptor.
If this occurs, you may need to check the following:
• WPS is working on your router
• Signal is reaching the adaptor
• DHCP addresses are available
• Your router is compatible with the adaptor.
For a list of compatible routers or if you are still experiencing issues connecting your router to the
Wi-Fi Adaptor, please contact your local Mitsubishi Electric Office, as listed on the back cover of
this guide.
Main causes that WPS failed are as follows:
Communication distance (from the Wi-Fi Adaptor to access point), access point settings
(encryption, authentication, limit of connections, etc.) Refer to the router's instruction manual
for more information.
Switch Function
(1) WPS switch
The WPS switch is used for pairing the Wi-Fi Adaptor with the access point. There are two types of
WPS: push button configuration (WPS-Push) and PIN code method (WPS-PIN).
• WPS-Push
Hold down the WPS switch for 2 seconds to start WPS-Push pairing.
When WPS-Push is enabled on the Wi-Fi Adaptor, LED1 starts flashing green (0.5-sec interval)
and the pairing can be completed by enabling WPS-Push on the access point.
• WPS-PIN
Hold down the WPS switch for 15 seconds to start WPS-PIN pairing. When WPS-PIN is enabled
on the Wi-Fi Adaptor, LED1 starts flashing green (0.2-sec interval) and the pairing can be
completed by enabling WPS-PIN on the access point.
Before using WPS-PIN, the PIN code of the Wi-Fi Adaptor needs to be set on the access point.
This product is only compatible with the access point that supports WPS.
(2) RESET switch
• Hold down the RESET switch for 2 seconds to reboot the system.
• Hold down the RESET switch for 15 seconds to initialize the Wi-Fi Adaptor to the factory default.
When the Wi-Fi Adaptor is reset to the factory default, ALL the configuration information will be
lost. Take great care in implementing this operation.
Specifications
Input Voltage
Power consumption
Size W×H×D (mm)
Weight
RF channel
Radio protocol
Encryption
Authentication
DC12.7V (from indoor unit)
MAX 2W
88×49×18.5
105g (including cable)
1ch ~ 13ch
IEEE 802.11b/g/n (20)
AES
PSK
11
Advertisement
Table of Contents
