Problem Of Raid System - NEC Express5800/R120g-1E Maintenance Manual

Chapter 1 Maintenance
[?] The following message appears when logging in the system on Windows Server 2008 R2
 Have you finished license authentication for Windows product?
→
The above message will appear if you use Windows Server 2008 R2 with the unauthenticated license.
Choose Get genuine now and proceed license authentication.
The above message is an example of request for license authentication.
The message displayed on screen is subject to change depending on the license.
5.5

Problem of RAID System

[?] Unable to rebuild the RAID array
 Is the capacity of the hard disk drive to be rebuilt correct?
→
Use a hard disk drive with the same capacity as that of the faulty hard disk drive.
 Is the logical drive RAID0?
→ RAID0 cannot be rebuilt because it has no redundancy. Replace the failed hard disk drive, reconfigure
the RAID array, and recover the drive using backup data.
[?] Unable to automatically rebuild the RAID array
 Did you wait for sufficient time until the hard disk drive was replaced?
→ Follow the steps below to use the auto-rebuilding feature.
(1) Remove a failure HDD.
(2) Wait for at least 90 seconds.
(3) Install a new HDD.
34
Express5800/R120g-1E Maintenance Guide
5. Troubleshooting