Table of Contents
Advertisement
5
Maintenance
Maintenance and inspection
If any problem is found during the following inspections and cannot be resolved, please
contact your sales representative or local Canon dealer.
Daily inspection
Cable
(1) Ensure that the cables are not damaged and the cable jackets are not torn so as to
expose the inside of the cables.
(2) Ensure that the power cord plugs are securely connected to both the equipment
AC inlet and the AC outlet.
(3) Ensure that there are no breaks or short-circuits in all pins of the detector connector
plugs.
(4) Ensure that there is no dust, dirt, or oil on the terminals of the wiring cable
connector.
Detector
(1) Ensure that there are no loose or missing screws.
(2) Ensure that there are no break or no deformation on the exterior of the detector.
(3) Ensure that there is no dust or foreign matter on the battery bay connector.
(4) Ensure that there are no breaks or short-circuits in the battery bay connector.
(5) Ensure that there is no dust, dirt, or oil on the terminals of the cable connector.
(6) Ensure that the battery cover is not damaged or bent.
(7) Ensure that there is nothing wrong with the rubber in the battery cover (foreign
objects, tears, cracks, etc.).
After turning on the power
Be sure to start the CXDI Control Software before performing the following inspection.
(1) Perform test exposure.
Ensure that captured images are displayed normally on the monitor.
17
Advertisement
Table of Contents
