Nokia ONT BGW320-505 Product Manual page 41

Install or replace a BGW320-505 indoor ONT
Replace a BGW320-505 indoor ONT
5
Replace the ONT with a new unit. For details,
indoor ONT".
6
Connect the Ethernet cables to the ONT and GE ports; see
connections" (p. 40)
7
Connect a telephone to the RJ-14 POTS port.
Contact your service provider for details, especially if you have an alarm system.
8
Fiber cables transmit invisible laser light. To avoid eye damage or blindness, never look directly
into fibers, connectors, or adapters.
Be careful to maintain a bend radius of no less than 1.5 in. (3.8 cm) when connecting the fiber
optic cable. Too small of a bend radius in the cable can result in damage to the optic fiber.
Connect the fiber optic cable with the SFP adapter into the SFP connector.
"BGW320-505 ONT connections" (p. 40)
9
Install the power supply according to manufacturer specifications.
Note: Observe the following:
•
10
Power up the unit by connecting the power cable; see
connections" (p. 40)
11
If applicable, press the WPS button to enable the WPS discovery mode on new WiFi devices.
June 2022
Issue 3
for the location of these ports.
DANGER
Hazard
WARNING
Equipment Damage
Units must be powered by a Listed or CE approved and marked limited power source
power supply with a minimum output rate of 12VDC, 4A.
for the location of the power input.
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-47753-AAAA-TCZZA
Chapter 4, "Install or replace a BGW320-505
Figure 4-2, "BGW320-505 ONT
shows the location of the fiber optic connector.
Figure 4-2, "BGW320-505 ONT
BGW320-505
Figure 4-2,
41