Toro Ultra Buggy 2500-T Operator's Manual page 43

Track Service (continued)
4. Using a water hose or pressure washer, remove dirt from each track system.
Ensure that you use high-pressure water to wash only the track area. Do not use a
high-pressure washer to clean the rest of the machine. Do not use high-pressure
water between the drive sprocket and the machine or you may damage the motor
seals. High-pressure washing can damage the electrical system and hydraulic valves
or deplete grease.
Ensure that you fully clean the road wheels, the front wheel, and the drive sprocket.
The road wheels should rotate freely when clean.
Checking the Track Tension
Place the tab
end of the tensioning tool should align with the edge of the tension arm
not correct, adjust the track tension
Note:
the tension arm should be 7.1 cm (2-13/16 inches).
3461-433A
G186007
of the tensioning tool
If the tensioning tool is not available, the distance between the nut and edge of
IMPORTANT
IMPORTANT
along the rear edge of the tension nut
G376373
Page 5–16
Front wheel
Track
Road wheel
Drive sprocket
, the other
. If the distance is
Maintenance: Drive System Maintenance