Advertisement
Quick Links
Rear Steering Indicator Kit
RT600 Traction Unit
Model No. 25520
Model No. 25520E
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
No parts required
Rear-steering indicator decal (125-6697)
Steering warning decal (125-8471)
No parts required
Position-indicator cable
Locknut (M10)
Ball joint
Plate
Flange nut (3/8 inch)
Clamp (3/8 x 3/8 inch)
Hex-head screw (3/8 x 1 inch)
No parts required
Locknut (M10)
Position-indicator pointer
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
–
1
1
1
1
1
1
1
–
2
1
Form No. 3386-813 Rev A
Installation Instructions
Use
Prepare the machine.
Apply the decals to the steering-indicator
plate.
Remove the right fender from the
machine.
Install the position-indicator cable.
Install the right fender onto the machine.
Install the position-indicator pointer.
Original Instructions (EN)
All Rights Reserved *3386-813* A
Printed in the USA
Advertisement
Related Manuals for Toro 25520
Summary of Contents for Toro 25520
- Page 1 Form No. 3386-813 Rev A Rear Steering Indicator Kit RT600 Traction Unit Model No. 25520 Model No. 25520E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Preparing the Machine Applying the Decals to the Steering-indicator Plate No Parts Required Parts needed for this procedure: Procedure Rear-steering indicator decal (125-6697) 1. Move the machine to a level surface. Steering warning decal (125-8471) 2. Set the parking brake and lower the attachments to the ground Procedure 3.
- Page 3 Removing the Right Fender from the Machine No Parts Required Procedure 1. Remove the 2 bolts and locknuts from the side of the back ROPS plate (Figure 2). Figure 3 1. Right fender 3. Front ROPS plate 2. Bolt and locknut 4.
- Page 4 Figure 6 Figure 4 1. Position-indicator cable 2. Rear-steering mount 1. Steering-indicator plate 3. Position-indicator cable 2. Front ROPS plate 4. Secure the position-indicator cable to the rear axle with the plate, locknut (M10), and the ball joint (Figure 7). 2.
- Page 5 Installing the Right Fender Installing the onto the Machine Position-indicator Pointer No Parts Required Parts needed for this procedure: Locknut (M10) Procedure Position-indicator pointer 1. Align the right fender with the holes where the 5 bolts and the 5 locknuts were removed in 3 Removing the Procedure Right Fender from the Machine (page 3).
-
Page 6: Operation
Operation Centering the Rear Wheels Center the rear wheels from left to right by adjusting the ball joint and the locknut at the end of the position-indicator cable until the indicator at the operator’s position shows that the wheels are straight (Figure 10). Figure 10 1. - Page 7 Notes:...