Toro 25468 Installation Instructions Manual

Block Heater Kit
RT1200 Trencher
Model No. 25468
Model No. 25468E
Installation
This product contains a chemical or chemicals known to the State of California to
1
Preparing to Install the Block
Heater
No Parts Required
Draining the Coolant
WARNING
Coolant is toxic.
• Keep coolant away from children and pets.
• If not reused, dispose of coolant in accordance
with local government regulations.
WARNING
Heated coolant spray or steam can cause personal
injury.
• Do not remove the recovery tank cap when the
engine is hot.
• Wait until the coolant temperature is below 50° C
(120° F) before removing the recovery tank cap.
Important: Do not pour coolant onto the ground or into
an unapproved container that can leak.
1. Move the machine to a level surface, shut off the
engine, and remove the key from the key switch.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
2. Allow the engine and cooling system to cool.
3. Remove the left and right side panels; refer to Operator's
Manual for the machine.
4. Remove the recovery-tank cap from the tank (Figure 1).
1
2
g024982
Figure 1
1. Recovery-tank cap
5. Place a drain pan with a minimum capacity of 23 L
(6 US gallons) under the open end of the drain hose
(Figure 3).
Original Instructions (EN) All Rights Reserved *3378-127* A
Printed in the USA
Form No. 3378-127 Rev A
Installation Instructions
2. Filler neck