Table of Contents
Advertisement
Mounting
WARNING!
Before installation, do the electrical safety precautions given in section
instructions.
Note: Before mounting the option module, set the supply voltage jumpers as described
above.
The option module is to be inserted into the option slot of the drive. See the drive
hardware manual for more information.
The module is held in place with plastic retaining clips, a locking tab and one screw.
The screw also provides the earthing of the cable shields connected to the module
and interconnects the GND signals of the module and the drive.
On installation of the module, the signal and power connection to the drive is
automatically made through a 20-pin connector.
Numbers in brackets refer to the layout drawing in section layout.
Mounting procedure:
1.
Pull out the locking tab (8)
2.
Insert the module carefully into the option slot until the retaining clips lock the
module into position
3.
Push in the locking tab (8)
4.
Fasten the screw (included) to the stand-off.
If you need to remove the adapter module after it has been installed into the drive,
use a suitable tool (e.g. small pliers) to carefully pull out the locking tab.
Note: Correct installation of the screw is essential for fulfilling the EMC requirements
and for proper operation of the module.
Installation 19
Safety
Advertisement
Table of Contents
