Table of Contents
Advertisement
3.3
Mounting Procedure
1. Cut out the control front panel to match the dimensions (mm) specified in
section
3.2 External and Cut-out
2. Mount the operator terminal into the cut-out. Insert the fixtures to the
holes on the unit and fasten the screws into the front panel. Do not tighten
the screws with too much or uneven force, or it may cause the deformation
of the operator terminal.
Max torque: 0.35-0.5 Nm (3.1-4.43 lb-in)
3. The operator terminal is to be installed within the angle of 0 to 135
shown below.
3.4
Grounding
To make sure that the operator terminal works properly and to prevent it from
radiating radio frequency noise, it must be connected to the earth ground.
ABB, 1SBC159107M0201
Dimensions.
STEP 1
STEP 2
Product Specifications
STEP 3
°
as
11
Advertisement
Table of Contents
