Panasonic AV-HS410E Operating Instructions Manual page 38

4. Specifications
DVI-D input/output
Reference input/output
Video delay time
Control I/O
Digital RGB:
X GA (1024768), WXGA (1280768), SXGA (12801024), WSXGA+ (16801050),
UXGA (16001200), WUXGA (19201200)
V ertical frequency: 60 Hz
Video format inputs:
D igital RGB: 1080/50p, 1080/59.94p
V ertical frequency: Same as system formats
Video format outputs:
D igital RGB: 1080/50p, 1080/59.94p, 1080/50i, 1080/59.94i, 720/50p, 720/59.94p
p p The input and output of analog signals are not supported.
p p Output support the high-resolution multi view mode:
Signals are output with a high resolution even when SD is set as the system mode.
(When high-resolution multi view mode has been enabled, MV is selected as the DVI-D OUT
output, and it is not possible to select MV with SDI OUT.)
p p This connector does not support the HDCP technologies.
Standard input/output: 1 line each (DVI-D IN, DVI-D OUT)
p p The DVI-I connector cable cannot be used.
p p For the DVI-D connector cable, use a cable with a length of up to 5 m.
In gen-lock mode: Black burst or Tri-level Sync input signals (with loop-through)
In internal sync mode: Black burst output signals 2
p p Same field frequencies as those of the system formats supported.
p p With the 1080/24PsF format, only gen-lock mode supported.
p p With the 1080/23.98PsF format, black burst with 10F-ID (SMPTE318M standard met) or TRI
signals supported.
When the frame synchronizer setting is "Off" and the up-converter setting is
"Off".
When the frame synchronizer setting is "On" or the up-converter setting is "On". 1 frame (F)
p p When the signals have passed through PinP, DVE, multi view, down-converter, DVI-IN or
DVI-OUT, a maximum delay of 1 frame is applied in each case.
LAN 10BASE-T/100BASE-TX (For IP control)
Connecting cable:
L AN cable (category 5 or above),
max. 100 m, STP (Shielded Twisted Pair)
cable recommended
p p When connecting to a hub (switching hub),
use a straight cable.
Use a crossover cable when connecting the
unit and computer on a 1:1 basis without
going through a hub.
p p Use with the same segment is recommended
for the equipment which is connected to the
unit.
If the unit is connected to equipment whose
segments are different, events dependent
upon the settings inherent to the network
equipment, for instance, may occur so
thoroughly check the connections with the
equipment to which the unit will be connected
prior to the start of operation.
EDITOR Used to control an editor
RS-422 control connector
Communication format
Baud rate
Character length : 8 bit
Parity
Stop bit
Flow control
: 38400 bps
: Odd
: 1 bit
: None
38
1 line (H)
RJ-45
D-sub, 9-pin, female