Panasonic AV-HS410E Operating Instructions Manual page 37

4. Specifications
SDI outputs
Composite input
(Option board)
Analog input
(Option board)
Analog output
(Option board)
DVI-I input
(Option board)
DVI-I output
(Option board)
DVI-D input
(Option board)
HD-SDI: HD Serial digital (SMPTE 292M)
SD-SDI: SD Serial digital (SMPTE 259M)
5 signal lines, standard: OUT1 2; OUT2 to OUT5 1 each
9 signal lines, maximum: O UT A1, OUT A2, OUT B1, OUT B2
(When two AV-HS04M7 boards are used)
HD: SMPTE 292M (BTA S-004B) standard complied with
• Output level 0.8 V [p-p] 10 %
• Rise time HD: Less than 270 ps
• Fall time HD: Less than 270 ps
• Difference between rise time and fall time
HD: Less than 100 ps
• Alignment jitter HD: Less than 0.2 UI (130 ps)
• Timing jitter HD: Less than 1.0 UI
• Eye aperture ratio More than 90 %
• DC offset 0 0.5 V
SD: SMPTE 259M standard complied with
• Output level 0.8 V [p-p] 10 %
• Rise time Less than 1.5 ns
• Fall time Less than 1.5 ns
• Difference between rise time and fall time
Less than 0.5 ns
• Jitter Less than 0.2 UI
Analog composite signal (NTSC/PAL) (1.0 V [p-p], 75 )
4 signal lines, maximum: I N A1, IN A2, IN B1, IN B2
(When two AV-HS04M6 boards are used; with loop-through)
SD/HD analog component Y/P
4 signal lines, maximum: I N A1, IN A2, IN B1, IN B2
(When two AV-HS04M2 boards are used)
SD/HD analog component Y/P
4 signal lines, maximum: O UT A1, OUT A2, OUT B1, OUT B2
(When two AV-HS04M4 boards are used)
p p 2 signal lines (OUT A1, OUT B1) when two AV-HS04M5 boards are used.
Analog/digital RGB:
XGA (1024768), WXGA (1280768), SXGA (12801024)
Vertical frequency: 60 Hz
p p This connector does not support the HDCP technologies.
4 signal lines, maximum: I N A1, IN A2, IN B1, IN B2
(When two AV-HS04M3 boards are used)
Analog/digital RGB:
XGA (1024768), WXGA (1280768), SXGA (12801024),
WSXGA+* (16801050), UXGA* (16001200), WUXGA* (19201200)
*: Selectable only when digital signals are output.
Vertical frequency: 60 Hz
p p This connector does not support the HDCP technologies.
2 signal lines, maximum: O UT A2, OUT B2
(When two AV-HS04M5 boards are used)
Digital RGB:
XGA (1024768), WXGA (1280768), SXGA (12801024), WSXGA+ (16801050),
UXGA (16001200), WUXGA (19201200)
Vertical frequency: 60 Hz
Digital RGB: 1080/50p, 1080/59.94p
p p Analog input signals are not supported.
p p This connector does not support the HDCP technologies.
4 signal lines, maximum: I N A1, IN A2, IN B1, IN B2
(When two AV-HS04M8 boards are used)
p p The DVI-I connector cable cannot be used.
p p For the DVI-D connector cable, use a cable with a length of up to 5 m.
/P (1.0 V [p-p], 75 )
B R
/P (1.0 V [p-p], 75 )
B R
37