Procedures For Using Configuration Utility In Uefi Mode; Create/Add Configuration - NEC EXP803 Maintenance Manual

Chapter 2 Useful Features
5.6

Procedures for Using Configuration Utility in UEFI Mode

5.6.1

Create/add configuration

Run LSI Software RAID Configuration Utility
Install the OS and Universal RAID Utility *1
Exit LSI Software RAID Configuration Utility
1. Run LSI Software RAID Configuration Utility.
2. From the TOP menu screen, select Virtual Drive Management, and then Create Configuration.
3. From Select RAID Level on the following screen, select the RAID level (RAID0, RAID1, or RAID10).
138
Create/add Virtual Drive
Check the Virtual Drive settings
Initialize the Virtual Drive
Perform Consistency Check
Express5800/R120f-1E Maintenance Guide
5. RAID System Configuration
*1 This step is not required if
an virtual drive has already
been installed.