Chapter 2
Install the New LCD Cover
WARNING
The LCD cover contains sheet metal with sharp edges. Handle
it carefully to avoid injury.
Do the following to assemble the new LCD cover:
1. Orient the LCD board to the rear half of the new LCD cover, as shown in
Figure 2-12. The spring finger on the side of the front half of the LCD
cover must be in the lower half of the cover, as shown. That spring finger
and one on the far side of the cover will engage slots in the rear half of the
LCD cover.
Rear Half of
New LCD Cover
Slots
Slot for
Spring Finger
Rectangular
Hole in Rear Half
of New LCD Cover
Figure 2-12. Assembling the New LCD Assembly
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
LCD Board
Spring Finger
on Side of Cover
Preparing the HP NetServer
Front Half of
New LCD Cover
21