Remove The Top Cover, Fan Cover, Fans, And Fan Cage - HP NetServer LXr 8500 Installation Manual

Chapter 2
Remove the Top Cover, Fan Cover, Fans, and Fan
Cage
Remove the entire top cover, fan cover, all fans, and the fan cage, as follows:
1. Remove the two screws at the front of the cover, then slide the cover back
approximately one half-inch (1 cm), as shown in Figure 2-5.
Screws
Top Cover
Figure 2-5. Removing the Entire Top Cover
2. Lift off the top cover, as shown in Figure 2-5.
3. Remove the screw on the front of the fan cover, as shown in Figure 2-6.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(HP NetServer LXr 8500 Shown)
Figure 2-6. Removing the Fan Cover
Preparing the HP NetServer
15