F200C, FL200C, F225B, FL225B
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
F225C
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Spacer
6
5
4 3
ZMU07549
7
6
5
4 3
ZMU07548
7. Thrust washer
Propeller nut tightening torque:
54 Nm (5.51 kgf-m, 39.8 ft-lb)
TIP:
2
Make sure to align the protrusions on the
spacer with the cutout areas of the propeller.
4.
Align the propeller nut slot with the pro-
1
peller shaft hole. Insert a new cotter pin
in the hole and bend the cotter pin ends.
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
1. Cotter pin
TIP:
2
If the propeller nut slot does not align with the
propeller shaft hole after tightening the pro-
peller nut to the specified torque, tighten the
1
nut further to align the slot with the hole.
EMU42573
Changing gear oil
F200C, FL200C, F225B, FL225B
EWM00801
WARNING
Be sure the outboard motor is securely
fastened to the transom or a stable
stand. You could be severely injured if
the outboard motor falls on you.
Maintenance
[ECM01892]
ZMU06956
1
75