Mitsubishi Electric 800 Series Instruction Manual page 12

Table of Contents

To use terminals PC and SD for a 24 VDC power supply, check the wiring to avoid short circuit between these terminals.

Terminal input specifications can be changed by analog input specification switchover (Pr.73). This terminal is used for voltage input only.

Terminal input specifications can be changed by analog input specification switchover (Pr.267). To select voltage input (0 to 5 V / 0 to 10

V), set the voltage/current input switch to the "V" position. To select current input (4 to 20 mA), set the voltage/current input switch to the

"I" position (initial setting). To use terminal 4 (current input at initial setting), assign "4" to any parameter from Pr.178 to Pr.184 (Input

terminal function selection) before turning ON the AU signal.

It is recommended to use 2 W 1 kΩ when the frequency setting signal is changed frequently.

Not required when calibrating the scale with the operation panel.

PRE-OPERATION INSTRUCTIONS

Table of Contents

Fr-e8te7