Mounting The Device To A Panel - Siemens RUGGEDCOM RX1501 Installation Manual

RUGGEDCOM RX1501
Installation Guide
Figure 3: DIN Rail Mounting
1. Panel/DIN Rail Adapter 2. DIN Rail 3. Screw
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.3.3

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM RX1501 can be equipped with panel/DIN rail adapters pre-installed on
each side of the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and mark the mounting holes on the panel.
Mounting the Device to a Panel
Chapter 2
Installing the Device
1
2
1
2
3
9