Blomberg LWF274411W User Manual page 19

4.3.11.2 Changing the auxiliary
function, speed and temperature
Depending on the step the programme has
reached, you can cancel or select the auxiliary
functions. See, "Auxiliary function selection".
You can also change the speed and
temperature settings. See, "Spin speed
selection" and "Temperature selection".
C
INFORMATION
• If no change is allowed, the relevant
light will flash for 3 times.
4.3.11.3 Adding or taking out laundry
1. Press the Start / Pause button to switch the
machine to pause mode. The programme
follow-up light of the relevant step during
which the machine was switched into the
pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out
the laundry.
5. Close the Loading Door.
6. Make changes in auxiliary functions,
temperature and speed settings if
necessary.
7. Press Start/Pause button to start the
machine.
4.3.12 Child Lock
Use Child Lock function to prevent children
from tampering with the machine. Thus
you can avoid any changes in a running
programme.
C
INFORMATION
• You can switch on and off the machine
with On / Off button when the Child
Lock is active. When you switch on
the machine again, programme will
resume from where it has stopped.
4.3.12.1 To activate the child lock:
Press and hold Auxiliary Function button
2 for 3 seconds. In the programme selection
display on the panel, "CL On" light will turn on.
You can release Auxiliary Function button 2
when this warning is displayed.
4.3.12.2 To deactivate the child lock:
Press and hold Auxiliary Function button
2 for 3 seconds. In the programme selection
display on the panel, "CL Off" light will turn on.
19 / EN
4.3.13 Canceling the programme
The programme is cancelled when the
machine is turned off and on again. Press and
hold On / Off button for 3 seconds.
C
INFORMATION
• If you press On / Off button when
the Child Lock is enabled, the
programme will not be cancelled. You
should cancel the Child Lock first.
• If you want to open the loading door
after you have cancelled the programme
but it is not possible to open the loading
door since the water level in the machine
is above the loading door opening,
then turn the Programme Selection
knob to Pump+Spin programme and
discharge the water in the machine.
4.3.14 End of programme
End LED appears on the display when the
programme is completed.
If you do not press any button for 10 minutes,
the machine will switch to OFF mode. Display
and all indicators are turned off.
Completed programme steps will be displayed
if you press On / Off button.
4.3.15 Your machine features
"Standby Mode".
After you switch on your machine with On-Off
button, if no program is started or no other
procedure is performed at the selection step
or no action is taken within approx. 10 minutes
after the selected program ends, your machine
will switch to OFF mode automatically. Display
and all indicators are turned off. Selected
programme data will be displayed if you press
On / Off button. Before you start the program,
check the accuracy of your selections. If
necessary, repeat them. This is not an error.
Washing Machine / User's Manual