Advertisement
7.
Secure the bottom of the cover using the bottom
bracket, 2 bolts (3/8 inch x 1-1/4 inch), and 2
nuts (1/4 inch) as shown in
Figure 13
1. Existing bolt (3/8 inch x
1-1/4 inch)
2. Bolt (1/4 x 1 inch) and nut
(1/4 inch)
8.
Place the hydraulic cover on the frame, and
secure the top of the cylinder cover using the
top bracket, 2 bolts (5/16 x 1-1/4 inch, previously
removed, and 1/4 inch x 1-1/4 inch) and 1 nut
(1/4 inch) as shown in
Note:
Position the tab on the hydraulic cover
over the top bracket.
9.
Secure the hydraulic cover using 1 bolt (5/16
x 1-1/4 inch, previously removed) as shown in
Figure
14.
Figure 14
1. Bolt (5/16 x 1-1/4 inch)
Figure
13.
g309895
3. Cylinder cover
Figure
13.
g323291
2. 15.6 cm (6-1/8 inch)
fastener strip
10.
Clean the surface of the hydraulic cover where
you are adhering the fastener strip
11.
Remove the backing from the remaining hook
and loop fastener strip and adhere it on the
hydraulic cover
12.
Adhere the hose cover to the fastener strip.
6
(Figure
(Figure
14).
14).
Advertisement
