Advertisement
2.
Place the left bracket at the bottom of the welds
of the wrap rod. Using the bracket as a template,
mark and drill holes (1/4 inch diameter) into the
frame
(Figure
6.
Figure 6
1. Left bracket
2. Drill a hole (1/4 inch
diameter) here.
3.
Using the upper and lower brackets as
templates, mark and drill holes (1/4 inch
diameter) into the frame
Figure 7
1. Drill a hole (1/4 inch
diameter) here.
2. Upper bracket
4.
Clean the surfaces on the frame near the
hydraulic cylinder and the hydraulic hoses.
5.
Remove the fastener strips from the cylinder
and hose covers, remove the backings, and
adhere the strips to the frame and hydraulic
cover
(Figure 8
and
strips as needed.
3. Wrap rod
(Figure
7).
3. Lower bracket
Figure
9). Trim the fastener
Note:
Do not install the 15.6 cm (6-1/8 inch)
fastener strip from the hose cover at this time.
g323307
Fastener Strip Locations for Cylinder Cover
1. 15.2 cm (6 inch) fastener
strip
2. 22.9 cm (9 inch) fastener
strip
g323100
Fastener Strip Locations for Hose Cover
1. 8.9 cm (3-1/2 inch)
fastener strip
2. 13.3 cm (5-1/4 inch)
fastener strip
4
Figure 8
3. 8.9 cm (3-1/2 inch)
fastener strip
4. 22.2 cm (8-3/4 inch)
fastener strip
Figure 9
3. 10.8 cm (4-1/4 inch)
fastener strip
g323099
g323224
Advertisement
