R Side Cover Assembly Section; Handle Assembly Section - JVC GY-HM600U Service Manual

3.2.2 Removing the TC board (See Figure 2)
• Remove teh grip cover assembly.
(1) Pull out the wires from the connectors CN1212, CN1211,
CN1213 and CN1214
(2) Remove the two screws B attaching the TC board, and
then remove the TC board.
CN1213
CN1214
B
3.2.3 Removing the seesaw assembly (See Figure 3)
• Remove the grip cover assembly and TC board.
(1) Remove the two screws C attaching the seesaw assembly,
and then remove the seesaw assembly.
C
3.3

R Side cover assembly section

3.3.1 Removing the GAIN board (See Figure 1)
(1) Pull out the wire from the connector
board.
(2) Remove the three screws A attaching the GAIN board, and
then remove the GAIN board.
GAIN Board
1-8 (No.HC047<Rev.001>)
on the TC board.
CN1211
CN1212
TC Board
Fig.2
Seesaw assembly
Fig.3
CN1413 on the GAIN
CN1413
A
Fig.1
3.3.2 Removing the R OPE unit (See Figure 2)
• Remove the GAIN board.
(1) Remove the eight screws B attaching the R OPE unit, and
then remove the R OPE unit.
B
B
3.4

Handle assembly section

3.4.1 Removing the handle cover T (See Figure 1, 2 and 3)
(1) Remove the one screw A attaching the shoe spring, and
then remove the shoe spring.
C
(2) Remove the two screws B attaching the shoe, and then re-
move the shoe.
(3) Remove the two screws C attaching the handle cover T.
Shoe
R OPE Unit R OPE Unit R OPE Unit
B
Fig.2
A
Shoe spring
Fig.1
Handle cover T
C
B
Fig.2
B
C