JVC GY-HM600U Service Manual page 10

(2) Pull out the wires from the connectors
on the XLR board.
CN506
(3) Remove the four screws J attaching the terminal, and then
remove the XLR board.
J
3.4.5 Removing the monitor assembly and AVR board (See
Figure 14, 15, 16, 17 and 18)
(1) Remove the two screws K attaching the joint cover, and
then remove the joint cover and hinge cover.
K Joint cover
Hinge
cover
K
1-10 (No.HC047<Rev.001>)
H
H
Fig.11
CN506 and
CN503
Fig.12
Fig.13
Fig.14
(2) Remove the one screw L attaching the FFC, and then pull
out the wire from the connector CN1806.
(3) Remove the two screws M attaching the hinge, and then
remove the monitor assembly.
Monitor
assembly
CN503
(4) Remove the one screw N, and then remove the front guard.
(5) Remove the six screws P and the one screw Q attaching
the OPE cover, and then remove the OPE cover.
Q
P
(6) Remove the two screws R attaching the volume knob, and
then remove the volume knob.
• When attaching the volume knob, turn in the direction of
an arrow, and attach so that "0" becomes a position of a
figure.
M CN1806
L
M
Fig.15
Front guard
N
P
P
P
AVR Board
P
Fig.16
R
"0"
Fig.17
P