JVC GY-HM600U Service Manual page 19

No. Adjustment Adjustment Jig
item type
10 -
OIS Drive Automatic
adjustment
11
INGAIN and Automatic Mini
ANALOG- adjustment studio
GAIN
12
AF Filter ND Semiauto Mini
1/16 adjustment studio
13
AF Filter ND Semiauto Mini
1/64 adjustment studio
14 -
White blem- Automatic
ish adjustment
Signal Adjustment standard Adjustment
point
-
White
chart
White
chart
White
chart
- (IRIS
CLOSE)
Adjustment Procedure
value range default value
(1) Choose ADJ tab -> OIS Drv tab,
(2) After pressing the [START] button,
(3) It will be completed when displayed
(1) Prepare an adjustment environ-
(2) Set Record Format to 1920 x 1080,
(3) Choose ADJ tab -> Ingain tab,
(4) It will be completed when displayed
(1) Set ND filter to the 1/16 position.
(2) Set Record Format to 1920 x 1080,
(3) Choose ADJ tab -> AF Filter tab,
(4) It will be completed when displayed
(1) Set ND filter to the 1/64 position.
(2) Set Record Format to 1920 x 1080,
(3) Choose ADJ tab -> AF Filter tab,
(4) It will be completed when displayed
(1) Wait about 30 minutes for pre-heat-
(2) Set Record Format to 1920 x 1080,
(3) Choose ADJ tab -> BPD tab, press
(4) It will be completed when displayed
press the [START] button.
adjust so that the shake of a monitor
screen comes to minimum, while vi-
brating a camera by hand.
as Complete.
ment of 3000K (Mini studio or
something).
24p(HQ), if it has not been set so.
Choose SETTING1 tab, input 4 into
the "Video Format Change" column
and then press the [Write] button.
press the [START] button.
as Complete.
60i(HQ) or 1440 x 1080, 60i(HQ), if
it has not been set so. Choose
SETTING1 tab, input 0 into the "Vid-
eo Format Change" column and
then press the [Write] button.
press the [START] button of ND 1/
16.
as Complete.
60i(HQ) or 1440 x 1080, 60i(HQ), if
it has not been set so. Choose
SETTING1 tab, input 0 into the "Vid-
eo Format Change" column and
then press the [Write] button.
press the [START] button of ND 1/
64.
as Complete.
ing the camera.
60i(HQ) or 1440 x 1080, 60i(HQ), if
it has not been set so. Choose
SETTING1 tab, input 0 into the "Vid-
eo Format Change" column and
then press the [Write] button.
the [START].
as Complete.
(No.HC047<Rev.001>)1-19