Replacing The Battery - Toro Dingo 323 Operator's Manual

Note: Dispose of the used oil at a certified recycling
center.
1
Figure 19
1. Oil drain valve
7. Remove the old filter and wipe the filter adapter
(Fig. 20) gasket surface.
8. Pour new oil of the proper type in through the center
hole of the filter. Stop pouring when the oil reaches the
bottom of the threads.
9. Allow a minute or two for the oil to be absorbed by
filter material, then pour off the excess oil.
10. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Fig. 20).
1
Figure 20
1. Oil filter
2. Gasket
11. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 20).
12. Remove the oil fill cap and slowly pour approximately
80% of the specified amount of oil in through the
valve cover.
13. Check the oil level; refer to Checking the Oil Level,
page 12.
2
m–3216
2. Drain hose
3
2
m–1256
3. Adapter
24
14. Slowly add additional oil to bring the level to the F
(full) mark on the dipstick.
15. Replace the fill cap.

Replacing the Battery

When the battery no longer holds a charge, replace it.
Important
Use only a genuine Toro replacement
battery.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
1. Park the traction unit on a level surface, raise the
loader arms, and install the cylinder locks; refer to
Using the Cylinder Locks, page 17.
2. Stop the engine and remove the key.
3. Remove the hood; refer to Removing the Hood,
page 22.
4. Remove the wing nuts and bar securing the battery
(Fig. 21).
3
4
Figure 21
1. Battery
2. Bar
3. Positive cable
5
2
1
m–4391
4. Rubber cover
5. Negative cable