Advertisement

Power Clear
Model No. 38472—Serial No. 316000001 and Up
Model No. 38473—Serial No. 316000001 and Up

Introduction

WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
This machine is intended to be used by residential
homeowners. It is designed primarily for removing
snow from paved surfaces, such as driveways and
sidewalks, and other surfaces for traffic on residential or
commercial properties. It is not designed for removing
materials other than snow, nor is it designed for clearing
off gravel surfaces.
This document is intended as a setup and quick start
guide only. For complete operating and maintenance
information as either an interactive manual or printable PDF
go to WWW.TORO.COM/EN-US/PARTS/PAGES/
PARTSLOOKUP.ASPX and enter your model number. You
can access this page by scanning the following QR code:
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready.
Figure 2
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Figure 1
identifies the location of the
Register at www.Toro.com.
518 ZR/ZE Snowthrower
model and serial numbers on the product. Write the numbers
in the space provided.
1. Model and serial number location
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This Operator's Start Guide uses 2 words to highlight
information. Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
For models with stated power, the net power of the engine was
laboratory rated by the engine manufacturer in accordance
with SAE J1940. As configured to meet safety, emission, and
operating requirements, the actual engine horsepower on this
class of snow thrower will be significantly lower.
Form No. 3396-416 Rev A
Operator's Start Guide
Figure 2
Figure 3
Original Instructions (EN)
All Rights Reserved *3396-416* A
Printed in the USA
(Figure
3),

Advertisement

Table of Contents
loading

Summary of Contents for Toro Power Clear 518ZR

  • Page 1: Introduction

    Figure 1 Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready.
  • Page 2: Table Of Contents

    Contents Safety Introduction ..............1 This machine meets or exceeds the B71.3 specifications Safety ................2 of the American National Standards Institute in effect Safety and Instructional Decals ......... 2 at the time of production. Preparing the Machine for First Use ........3 •...
  • Page 3: Preparing The Machine For First Use

    117-7713 1. Warning—read the Operator’s Start Guide and the Operator's 4. Fuel spill hazard—do not tip machine forward or backward. Manual. 2. Cutting/dismemberment hazard, impeller—stop the engine 5. To engage the auger, squeeze the control bar. before leaving the machine. 3.
  • Page 4: Filling The Engine With Oil

    Filling the Engine with Oil Your machine does not come with oil in the engine, but it does come with a bottle of oil. Important: Before starting the engine, fill the engine with oil. Max fill: 0.35 l (12 oz), type: automotive detergent oil with an API service classification of SJ, SL, or higher.
  • Page 5: Filling The Fuel Tank

    Note: Moving the Z-fitting higher decreases the gap between the control bar and the handle; moving it lower increases the gap. 3. Hook the spring to the adjuster link and slide the spring cover over the adjuster link. 4. Check the adjustment; refer to Checking the Control Cable.
  • Page 6: Starting The Engine

    Figure 10 1. 1/2 inch (13 mm) Figure 12 Note: For best results, purchase only the quantity of gasoline 1. Choke lever that you expect to use in 30 days. Otherwise, you may add fuel stabilizer to newly purchased gasoline to keep it fresh for up to 6 months.
  • Page 7 (Model 38473 only). Unplug the power cord whenever you are not starting the machine. For more information about operation and maintenance, go to WWW.TORO.COM/EN-US/PARTS/PAGES/ PARTSLOOKUP.ASPX . Figure 14 1. Electric-start button Note: Use only a UL-listed, 16-gauge extension cord recommended for outdoor use that is not longer than 15 m (50 feet).
  • Page 8 Notes:...
  • Page 9 Notes:...
  • Page 10 Such use will not reduce the warranty obligations of The Toro Company. 10. Add-on or modified parts that are not approved by The Toro Company may not be used. The use of a non-approved add-on or modified parts by the purchaser will be grounds for disallowing a warranty claim.
  • Page 11 1. Fuel System Parts • Carburetor and internal parts • Cold starting enrichment (primer or choke) • Fuel pump • Fuel line, fittings, and clamps • Fuel tank, cap, and tether • Carbon canister 2. Air Induction System • Air cleaner •...
  • Page 12 Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.

This manual is also suitable for:

Power clear 518ze3847238473

Table of Contents