Toro 38472 Operator's Manual

Toro 38472 Operator's Manual

Power clear 518 snowthrower
Hide thumbs Also See for 38472:

Advertisement

Power Clear
Model No. 38472—Serial No. 404621000 and Up
Model No. 38473—Serial No. 404621000 and Up

Introduction

This machine is intended to be used by residential
homeowners. It is designed primarily for removing
snow from paved surfaces, such as driveways and
sidewalks, and other surfaces for traffic on residential
or commercial properties. It is not designed for
removing materials other than snow, nor is it designed
for clearing gravel surfaces. Using this product for
purposes other than its intended use could prove
dangerous to you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information.
1. Model and serial number location
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Figure 1
Figure 1
Register at www.Toro.com.
518 Snowthrower
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
g293191
Form No. 3432-459 Rev A
Operator's Manual
Figure 2
Safety-alert symbol
Original Instructions (EN)
All Rights Reserved *3432-459* A
Printed in Mexico
g000502

Advertisement

Table of Contents
loading

Summary of Contents for Toro 38472

  • Page 1: Introduction

    Note emphasizes general information additional information, contact an Authorized Service worthy of special attention. Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 identifies the location of the model and serial numbers on the product.
  • Page 2: Table Of Contents

    To locate 5 Adjusting the Control Cable......6 a dealer convenient to you, access our website Product Overview ............. 8 at www.Toro.com or contact our Toro Customer Specifications ............ 8 Care Department at the number(s) listed in your Attachments/Accessories ........8 Emission Control Warranty Statement.
  • Page 3: Safety

    Safety This machine has been designed in accordance with ANSI/OPEI B71.3 specifications. General Safety This product is capable of amputating hands and feet and of throwing objects. Always follow all safety instructions to avoid serious personal injury. • Read and understand the contents of this Operator’s Manual before you start the engine.
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal120-0149 120-0149 1. Primer 4. Pull the key to switch the engine switch off.
  • Page 5: Setup

    Setup Installing the Handle No Parts Required Procedure g253607 Installing the Discharge Chute No Parts Required Procedure g255436...
  • Page 6: Installing The Recoil-Start Handle

    Installing the Recoil-Start Handle No Parts Required Procedure g253609 Filling the Engine with Oil No Parts Required Procedure g253610...
  • Page 7: Adjusting The Control Cable

    Adjusting the Control Cable No Parts Required Procedure Refer to Checking and Adjusting the Control Cable (page 15).
  • Page 8: Product Overview

    Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories.
  • Page 9: Operation

    Filling the Fuel Tank Operation • For best results, use only clean, fresh (less than Note: Determine the left and right sides of the 30 days old), unleaded gasoline with an octane machine from the normal operating position. rating of 87 or higher ((R+M)/2 rating method). •...
  • Page 10: Checking The Engine-Oil Level

    Checking the Engine-Oil Level Service Interval: Before each use or daily g293231 Figure 11 During Operation • When not actively clearing snow, disengage power to the auger. During Operation Safety • Exercise extreme caution when operating the machine on walks or roads. Stay alert for hidden hazards or traffic.
  • Page 11: Starting The Engine

    Starting the Engine Electric-Start Model Note: Remove your glove when you push in the primer so that air cannot escape from the primer hole. Important: Do not use the primer or the choke if the engine has been running and is hot. Excessive priming may flood the engine and prevent it from starting.
  • Page 12: Engaging The Rotor Blades

    g253666 Figure 13 Engaging the Rotor Blades Disengaging the Rotor Blades To engage the rotor blades, hold the control bar against the handle (Figure 14). To disengage the rotor blades, release the control bar (Figure 15). g011577 Figure 14 g011578 Figure 15...
  • Page 13: Shutting Off The Engine

    Shutting Off the Engine To shut off the engine, pull the ignition key outward until it clicks into the O position (Figure 16) or move the choke lever fully to the right (B of Figure 13). g011581 Figure 18 1. Trigger 2.
  • Page 14: Operating Tips

    scraper lifts off the ground and snow escapes behind wait for all moving parts to stop, and remove ice the machine. and snow from the machine. • Clean off any snow and ice from the base of the Operating Tips chute.
  • Page 15: Maintenance

    Check all fasteners at frequent intervals for proper tightness to ensure that the machine is in safe working condition. • Do not change the governor settings on the engine. Purchase only genuine Toro replacement parts g011568 and accessories. Figure 20 1. Control bar 2.
  • Page 16: Inspecting The Rotor Blades

    g011544 Figure 22 1. The wear-indicator hole is 2. The wear-indicator hole is intact; you do not need to exposed; replace the rotor g006402 replace the rotor blades. blades and scraper. Figure 21 1. Adjuster link 3. Spring cover 2. Z-fitting 4.
  • Page 17: Servicing The Spark Plug

    Service Interval: Yearly—Service the spark plug and crankcase. replace it if necessary. 2. The oil level is too high—remove oil from Use a Toro spark plug (Part No. 119-1961). the crankcase. Shut off the engine and wait for all moving parts to stop. Note:...
  • Page 18: Replacing The Drive Belt

    Replacing the Drive Belt If drive belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise damaged, replace the belt. Remove the 4 bolts that hold the drive-belt cover (Figure 26) in place. g011642 Figure 27 1. Belt guide 2. Engine pulley Note: Do not distort or damage the belt guide.
  • Page 19: Storage

    Storage Storage Safety • Shut off the engine, remove the key, and wait for all movement to stop before you leave the operator’s position. Allow the machine to cool before adjusting, servicing, cleaning, or storing it. • Fuel fumes are highly flammable, explosive, and dangerous if inhaled.
  • Page 20 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.

This manual is also suitable for:

38473

Table of Contents