DeWalt DXFP210050 Instruction Manual page 6

English
WARNING:
Never use fall protection equipment for purposes other than those for which it was designed. Fall
protection equipment should never be used for towing or hoisting.
WARNING:
The product shall be used by trained personnel or under supervision of qualified personnel. The
steel snap hook end of the life line should be connected to an approved anchor (anchor selection must be done
with relative normative reference). The steel snap hook end of the rope grab assembly shall be attached to the
user's front mounted attachment point of the full body harness. D
rope grab assembly having energy absorption mechanism. If user needs to assemble both products, it should be
done by authorized personnel only.
VERTICAL LIFELINES
WARNING:
Read all safety warnings, instructions, illustrations and specifications provided with this product.
Failure to follow all instructions listed below may result in serious injury.
a ) For use by ONE person only. D
lifelines have a minimum tensile strength of 6000
lbs. / 27kN. ( OSHA requires a minimum tensile
strength of 5000 lbs. 22.2kN).
b ) Lifeline must be kept clean.
c ) Never allow the lifeline to become slack or to pass
under or entwine around arms, legs, neck, or any
other obstacle.
d ) Do not tie knots in lifelines.
e ) Elastic elongation of no more than 22% at 8kN
load is allowed.
f ) Store in a clean, dry area, free of exposure to
fumes or corrosive elements.
g ) Avoid excessive heat, steam, or long periods of
sunlight.
4
WALT vertical
E
Polysteel Twisted Rope
WALT provides pre-installed lifelines with
E
The D WALT vertical lifeline assembly, comes with 5/8"
E
Polysteel twisted rope, a permanently attached snap
hook and rope grab with attached energy absorber.
The assembly uses an ANSI rated 3600 LBS snap hook on
one end for attachment to an anchor point.
The Lifeline should always be used along with its rope
grab assembly and an energy absorbing mechanism.