Canon imagePRESS Server M10 Service Manual page 95

6.
CAUTION:
• Be sure to use the network cable with Category 5e
or higher. In addition, a shielded type (STP cable)
is recommended. When using the non-shielded
type (UTP cable), it may influence the surrounding
electronic imagePRESS Server via network cable.
• Use the correct power cord to mach the location/
area of installation. Make sure not to leave unused
power cord at the site.
Straight Ethernet Cable (3.0 m)
(for network connection)
2x
7.
Connect the power plug to the outlet of the host
machine.
8.
Connect the power plug to the outlet of the
imagePRESS Server.
CAUTION:
Be sure to use an outlet of a system different from that
of the host machine.
9.
EUR 2x
USA 1x
10.
11.
12.
13.
89
6. INSTALLATION PROCEDURE
Turn ON the power switch of the imagePRESS
Server
Turn ON the main power switch of the host machine.
After seeing "Perform Apply Setting Changes from
Settings/Registration." displayed on the host
machine's Touch Panel, select [Apply Set. Changes]
> [Yes].
NOTE:
• The host machine automatically restarts. It may take
approx. 10 minutes before the message appears.
• The imagePRESS Server is automatically restarted
only at the first time when it is connected. It takes
about approx. 5 minutes until it is ready for use. Do
not press the buttons on the imagePRESS Server
until it is ready for use.
Check that the value of the following service mode
is "471".
COPIER > OPTION > INT-FACE > CNT-TYPE
Exit from Service Mode.