Canon imagePRESS Server M10 Service Manual page 66

2. If possible, print the Configuration pages (see
The Configuration pages contain a list of any installed options and a record of the customer's current Setup configuration.
3. If you are reinstalling the same version of system software, back up the current system configuration (see
up the system configuration" on page
4. Shut down the imagePRESS Server
on page 11). Leave the imagePRESS Server power switch in the ON (|) position.
5. Power off the printer using the main power switch.
The imagePRESS Server will automatically shut down.
6. Move the imagePRESS Server power switch to the OFF (O) position.
7. Disconnect all external cables from the imagePRESS Server, except the power cable and the printer interface cable.
NOTE:
Be sure to leave the power cable connected between the imagePRESS Server and the power outlet.
8. Flip the service switches to boot mode (set the switch 1 to ON; switch 2 to OFF).
NOTE:
The LED display is mounted in upside-down orientation.
No.
1 Service switches
2 LED display
3 Flip the service switches from normal (OFF OFF) position...
4 ...to service mode (ON) position.
9. Attach the prepared USB flash drive to one of the USB connectors on the imagePRESS Server.
NOTE:
If dust covers are attached to the USB connectors, remove dust cover using needlenose pliers.
10. Power on the imagePRESS Server by pressing the power switch to set ON (|), and then power on the printer using
the main power switch on the front.
Make sure that the imagePRESS Server turns on.
"Printing the Configuration pages" on page
46).
(see"Starting, shutting down, rebooting, and restarting the imagePRESS Server"
1 2
Figure 30: Service switches on the imagePRESS Server
60
4. INSTALLING SYSTEM SOFTWARE
3
4
Name
66).
"Backing