Toro TX 1000 Installation Instructions Manual page 3

2
Installing the Receiver
Tubes
Parts needed for this procedure:
2 Front receiver tube
1 Left, rear receiver tube
1 Right, rear receiver tube
1 Windshield bracket
2 Hose guard
2 Bolt (1/4 x 1-1/2 inches)
2 Bolt (5/16 x 1 inch)
2 Bolt (5/16 x 1-1/4 inches)
2 Bolt (1/4 x 2 inches)
4 Locknut (1/4 inch)
Procedure
1. Remove the 2 bolts and locknuts from the fuel
tank lock plate to the machine
the locknuts.
1. Bolt (5/16 x 7/8 inch)
2. Install a front receiver tube to the right side of
the machine using a bolt (1/4 x 1-1/2 inches)
and locknut (1/4 inch) as shown in
(Figure 1). Retain
Figure 1
2. Locknut (5/16 inch)
Figure
1. Right, rear receiver tube
2. Bolt (5/16 x 1 inch) and
retained locknut (5/16
inch)
3. Bolt (5/16 x 1-1/4 inches)
and retained locknut (5/16
inch)
3. Install the right, rear receiver tube using a bolt
(5/16 x 1) and a retained locknut (5/16 inch) as
shown in
4. Install the hose guard to the bracket of the rear
receiver tube using a bolt (5/16 x 1-1/4 inch)
and a retained locknut (5/16 inch) as shown in
Figure
5. Repeat steps
the machine.
6. Install the windshield bracket, using the 2 bolts
(1/4 x 2 inches) and 2 locknuts (1/4 inch) to also
secure the front receiver tubes and the hose
guards to the frame
g341650
2.
3
Figure 2
4. Hose guard
5. Bolt (1/4 x 1-1/2 inches)
and locknut (1/4 inch)
6. Front receiver tube
Figure 2.
2.
2 through 4 for the other side of
(Figure 3
g323568
and Figure 4).