Installation and operation manual
WARNING
WARNING
7.2 Connection work
For electrical installation work to be carried out, the following prerequisites must be fulfilled and the
preparatory tasks must have been completed.
Tools
•
1.5 mm slotted screwdriver
•
Wire stripping pliers
1.
A protective contact socket is installed within reach (<3 m (19 ft)) of the place of installation of
the QWIK‑PURE
2.
Fusing of the protective contact socket is sufficiently dimensioned for the power consumption.
3.
Assembly of the QWIK‑PURE
Inappropriate electrical installation!
Improper electrical installation of the product and the accessories can lead to
personal injury and damage to property as well as impair operation when working
on the product and accessories.
•
Check all plug-type connections for a correct fit.
•
Avoid stumbling hazard through appropriate cable routing.
•
Avoid mechanical strain on the cables.
Ingress of moisture or foreign bodies!
Water and foreign objects can get into the opened FRC control unit or into the
opened electrical connections if electrical connections are disconnected or if
the FRC control unit is opened. Ingress of water or foreign bodies can lead to
accidents, personal injury and damage to property as well as impairments in
operation.
•
Protect the FRC control unit and the electrical connections from splash water
and moisture.
•
Open the FRC control unit and disconnect the electrical connections in a dry
location only.
•
Do not insert any foreign objects into the openings of the FRC control unit.
•
Keep all contact surfaces and openings free of dirt and moisture.
Prerequisites
•
Cable for the power supply
•
Modbus cable
•
Included connector
Preparatory tasks
.
®
is complete.
®
Material
QWIK-PURE
Protective equipment
Always to be worn:
®
59 | 124